Run local file after AnyConnect Establishes a Connection

[paul_romsos]

We've installed a pair of ASA 5525's recently and ran into one feature that was present on our ancient Juniper VPN solution that I can't figure out on the new ASAs with AnyConnect.  With the old solution when the VPN client on a user's machine successfully connected into the network we would launch a program on the machine that would then map the user's shared directories and printers - is there a similar solution with the ASA\AnyConnect setup?  There is a batch file that is present in the same location on every one of our company's assets that could be called to run this program, I just can't figure out a way to actually run the batch file, if it's possible.

One solution to the issue is to have AnyConnect launch prior to user login, then the program will run when the user logs in to Windows, but I'd like to avoid this scenario if possible - I don't want AnyConnect launching prior to user login.  

Any insight or suggestions would be greatly appreciated.

Thanks.

Paul

[jan.nielsen · Accepted solution]

Yes, that feature exists in anyconnect.

http://www.cisco.com/c/en/us/td/docs/security/vpn_client/anyconnect/anyconnect40/administration/guide/b_AnyConnect_Administrator_Guide_4-0/customize-localize-anyconnect.html#ID-1408-00000396

[paul_romsos]

That should do exactly what I wanted.  Thanks.