Site-to-site and dial-up VPN connections with IPSec Stateful Failover

[alec.waters]

Hi,

I'm planning to use a pair of 3845 routers configured for IPSec Stateful Failover to handle inbound VPN connections (no more than about 50 concurrent connections). These routers will also handle CBAC and inter-vlan routing for "internal" vlans.

Can I configure IPSec Stateful Failover to concurrently handle both site-to-site VPNs (from remote routers) and dial-up VPNs from the Cisco VPN Client software? Is there anything special I need to look out for?

thanks a lot,

alec

[drolemc]

I had a look at the 12.3T feature guide and did not find anything to suggest that what you are trying is not possible. You could refer to the same at http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_feature_guide09186a00802d03f2.html#wp1121665