Site-to-site VPN between 2 sites using SAME Subnet

[bhw3]

Hi Ciscoers,

I want to configure site-to-site VPN using 2 PIXs 515E but both sites will share the same subnet and broadcast. I have to use NAT because I only have one public IP on each site but i preferably don;t want to nat all traffic that go through the VPN tunnel.

How can I do that?

Right now, I am using OpenVPN from sourceforge.net to configure VPN between 2 sites (share the same subnet and broadcast) using "Bridging" mode but we are planning to use PIX VPN.

Thanks in advance.

-b-

[jmia]

Hi,

Please refer to the following post by Glenn Fullager of Cisco System. Very well explained on your requirement:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40.1dd6060d/0#selected_message

Let me know if you need further help.

Jay

[bhw3]

Thanks for the link Jay.

I will try it.

-bh-