Start Before Logon feature in Linux for Cisco Anyconnect

[PashanNone]

Hello All,

ASA 8.X: AnyConnect Start Before Logon Feature Configuration - Cisco

The above Link mentions SBL Feature for Windows Client.

Can anybody help me how to enable SBL feature for Linux to activate?

Best Regards

[Marius Gunnerud · Accepted solution]

Have a look at the following link.  Hope it helps:

https://www.cisco.com/c/en/us/support/docs/security/anyconnect-secure-mobility-client/214612-configure-anyconnect-secure-mobility-cli.pdf

[PashanNone]

Hello Marius,
Actually I was looking for a feature in Linux similar to the item shown below for Windows using AnyConnect.
The document you mentioned doesn't provide similar information.
Once I login I am able to use Cisco Anyconnect either in CLI mode or in GUI Mode without any issue within the Linux Machine.
Question is how do I login to VPN [Internet is active already in Linux Machine] before Login session?
What components I need to be installed on Linux Machine related to Cisco Anyconnect to behave similar to snippet shown below in the attached picture?

Pre-Login Access Provider (PLAP) or Start Before Login (SBL)

Best Regards