Static Multiple IP on Cisco ACS for Anyconnect

[jewfcb001]

If We need to fix static multiple IP  on Cisco ASA 5.7 for Connect VPN via Cisco ASA Anyconnect , What will i do ?

Please suggestion me.

Thank you .

Sutirnanan  Phooton

[Rolando Valenzuela]

Static IPs for specific clients?

Lets say you have the pool 10.20.30.0/24 so you want the CEO, your pc, and your boss PC to always received the same IP when using anyconnect?

I tried to accomplished the same in the past but I couldn't find a easy solution, how many endpoints are we talking? you can uses a different connection profile for those users or if you have control over those PC you can use HostScan to determine the right device.

Here are few good reads for configuring HostScan:-
https://supportforums.cisco.com/document/74681/how-configure-anyconnect-host-scan

http://www.cisco.com/c/en/us/td/docs/security/asa/asa90/configuration/guide/asa_90_cli_config/vpn_hostscan.pdf

Regards.

Rolando A. Valenzuela

[jewfcb001]

Hi Rolando ,

Thank you for answer ,  I mean , I have 2 ASA and Install 2 Location , If I connect to  ASA at Location A , Client get 1 Static IP and  If I connect to  ASA at Location B Client get Static IP(difference IP from Location 1)

Thank you.

[Rolando Valenzuela]

I noticed you have another thread (https://supportforums.cisco.com/discussion/13161201/ip-local-pool-lease-timerecycle-delay-anyconnect-session) so I will reply only here.

I feel like you have a general struggle configuring AnyConnect in general, follow the setup wizard and you should be good to go.

https://www.youtube.com/watch?v=1oJ1JwYAC8w

The DCHP pool is configured during the wizard.

Rolando A. Valenzuela.