12-07-2004 10:59 AM - edited 02-21-2020 01:29 PM
I had an exam queston yesterday on the 642-501 (Securing Cisco IOS Networks) that i am having difficulty with.
The queston went as follows:
Company A purchased Company B. They want to have a VN using IPsec. Router A is already configured. Router B has isakmp enabled, but needs the following configured: hash, encryption, authentication, diffie-hellman group.
THEN the question adds that the VPN "needs to terminate on the serial interface".
I would not think this to be a problem normally. I would simply create a crypto map in ipsec and then apply it to the serial interface.
But the question only asks for IKE values to be configured. I tried within the simulation to configure the crypto map, but it was not part of the supported commands in the simulation...
Is there a way to apply ANYTHING or TERMINATE anything on the serial interface based upon the ISAKMP values alone? What am I missing here??
thx as always
Solved! Go to Solution.
12-07-2004 12:17 PM
I think they want you to configure the isakmp preshared key along with the serial interface address of the remote peer. I doubt if there is any other significance to that statement "terminate on the serial interface"
12-07-2004 12:17 PM
I think they want you to configure the isakmp preshared key along with the serial interface address of the remote peer. I doubt if there is any other significance to that statement "terminate on the serial interface"
12-07-2004 06:46 PM
Yep. That's it! It makes sense now.
Thank You.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide