Trouble establishing VPN between RV120 and ASA5512

[Steveri11]

I am having trouble establishing a site to site VPN tunnel between a remote site with an RV120 and the main office with an ASA5512. The difference between the UI on the RV120 and the ASDM on the ASA and the fact that the RV120 has no CLI are making it difficult for me to verify that all my settings match. 

The logs on the RV120 indicate that phase 1 is completing successfully but phase 2 fails:

Using IPsec SA configuration 10.17.0.0/24 <-> 10.50.0.0/24

Configuration found for xxx.xxx.xxx.xxx

Initiating new phase 2 negotiation: xxx.xxx.xxx.xxx[0]<=>xxx.xxx.xxx.xxx[0]

Error: Phase 2 negotiation failed due to to time up. c6bfd4752365537f:0e1b1b4e754fe194:eb93458b

[Marius Gunnerud]

What version is the RV120 running?  Have you tried upgrading the RV120?

--

Please remember to select a correct answer and rate helpful posts

[Steveri11]

Thank you for the reply. The running firmware is 1.0.5.9 which is the current version. 

[Marius Gunnerud]

on the ASA could you run the following debug commands and then try to send traffic over the tunnel:

debug crypto condition peer <RV120 public IP>

debug crypto ikev1 127

debug crypto ipsec 127

--

Please remember to select a correct answer and rate helpful posts

[Steveri11]

The tunnel never establishes. IKE phase 2 fails. 

[Marius Gunnerud]

IKE phase 2 is the encryption of data...IKE phase one establishes the tunnel.  Please run the debugs to see if you are seeing the same on the ASA.  If it is infact phase two that is failing check the encryption domain and make sure it is correct and a mirror image of eachother on the RV120 and ASA

--

Please remember to select a correct answer and rate helpful posts