VPN Remote access Any connect

[Greysky]

Hello Friends,

I'm using firewall cisco ASA to deploy VPN remote access via any connect software.

Normally, when use the command:

enable outside 

At the moment, VPN client will access to IP public of interface outside. But If I want to client will access to another IP public ( IP public using for NAT).

So how can I do it ?

I don't fine down any command concern it.

Can you help me ?

Thanks.

[Mohammed al Baqari]

Hi,

AnyConnect should be enabled on physical interface. You can not have
anyconnect enabled on natted IP by same ASA. However, if the interface is
having a private IP and you are natting it using a router then you can
enabled anyconnect on that interface and the router will take care of
forwarding the traffic.

**** please remember to rate useful posts.

[Rob Ingram]

Hi,
This is not possible. A VPN can only be establish to an IP address assigned to an interface on the ASA.

HTH

[Greysky]

Thanks