cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1027
Views
0
Helpful
4
Replies

Cisco vWSA not accessible on browsers

Asfandyar70754
Level 1
Level 1

Hey guys,

So I am trying to use Cisco vWSA on Vmware for practice but for some reason it is not accessible on browsers.

Earlier I tried Cisco vSMA and was able to access it on chrome & edge but vWSA is not accessible on any of the browser. I am able to ping it but for some reason it is not accessible on the browser.

1 Accepted Solution

Accepted Solutions

@Asfandyar70754 when you run through the initial configuration on the CLI did you enable http and https? You can re-run this using interfaceconfig then to connect to the management interface using a hostname (http://hostname:8080)

View solution in original post

4 Replies 4

@Asfandyar70754 what interface IP address are you attempting to connect to? M1?

From the CLI it will tell you the IP address and port (8080) to connect to for mgmt.

Have you configured the gateway on the WSA?

 

I have assigned IP address 192.168.63.221 and I have set gateway 192.168.63.1.

yes I am trying to access it using this IP but it is not accessible but it is pingable.

@Asfandyar70754 when you run through the initial configuration on the CLI did you enable http and https? You can re-run this using interfaceconfig then to connect to the management interface using a hostname (http://hostname:8080)

Thanks a lot Rob.

I didnt enable HTTP and HTTPS.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: