Hi, Anybody knows how to check ironport status interface? like checksum errors?
Thanks!
Solved! Go to Solution.
Unfortunately you will not get the native ifconfig result from CLI mode.
You will get some information about packets and errors from netstat like below.
Interface Details
Name Mtu Network Address Ipkts Ierrs Opkts Oerrs Coll
bce0 1500 00:26:b9:xx:xx:xx 0 0 0 0 0
bce0 1500 192.168.xx.xx/xx 192.168.x.xxx 0 - 0 - -
bce1* 1500 00:26:b9:xx:xx:xx 0 0 0 0 0
bce2 1500 00:26:b9:xx:xx:xx 1275969 0 0 0 0
bce3 1500 00:26:b9:xx:xx:xx 0 0 0 0 0
bge0 1500 00:10:18:xx:xx:xx 7709841 0 8870604 0 0
bge0 1500 10.66.xx.x/xx 10.66.xx.xx 7416495 - 8878601 - -
lo0 16384 772809 0 772809 0 0
lo0 16384 fe80:6::1/64 xxxxxx::xx 0 - 0 - -
lo0 16384 ::1/128 ::1 0 - 0 - -
lo0 16384 127.0.0.0/8 127.0.0.1 772809 - 772808 - -
Hello,
I am sure to what level the informaiton that you are after, but you can try to run 'netstat' from CLI mode.
Thanks,
Donny
Thanks for your help!
I need a command like "show interface detail or show interface status" to see errors, packets sent, packets received and so on. Can you help?
Thanks
Unfortunately you will not get the native ifconfig result from CLI mode.
You will get some information about packets and errors from netstat like below.
Interface Details
Name Mtu Network Address Ipkts Ierrs Opkts Oerrs Coll
bce0 1500 00:26:b9:xx:xx:xx 0 0 0 0 0
bce0 1500 192.168.xx.xx/xx 192.168.x.xxx 0 - 0 - -
bce1* 1500 00:26:b9:xx:xx:xx 0 0 0 0 0
bce2 1500 00:26:b9:xx:xx:xx 1275969 0 0 0 0
bce3 1500 00:26:b9:xx:xx:xx 0 0 0 0 0
bge0 1500 00:10:18:xx:xx:xx 7709841 0 8870604 0 0
bge0 1500 10.66.xx.x/xx 10.66.xx.xx 7416495 - 8878601 - -
lo0 16384 772809 0 772809 0 0
lo0 16384 fe80:6::1/64 xxxxxx::xx 0 - 0 - -
lo0 16384 ::1/128 ::1 0 - 0 - -
lo0 16384 127.0.0.0/8 127.0.0.1 772809 - 772808 - -
It's enough!
Thank for your help..