cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
950
Views
5
Helpful
3
Replies

SMAv disk full

Hi Guys, I have a M300v which I cannot ssh to because I get:

IOError: [Errno 28] No space left on device

and then get disconnected. I did try FTP but there are no large directories there. Under disk management in the GUI everything is within limits. Any ideas? Do I need to rebuild it?

 

Thanks!

3 Replies 3

balaji.bandi
Hall of Fame
Hall of Fame

If you have access to FTP see any old logs can remove which is not required, like gui logs.

Once that is done, another quick tip, since it is management reboot the SMA and check.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Hi, unfortunately still the same. I deleted all logs except current and rebooted. Same problem.

Hi, would recommend to open a TAC case for the engineer to check from the backend.

suspect there is an internal partitions that is not used for data partition that over usage and the engineer can checks why and what causing this from remote tunnel access.

 

Regards

Handy Putra

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: