cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
194
Views
5
Helpful
1
Replies
Highlighted
Beginner

Trying to block all but 1 URL

A customer has Ironport WSA, and they are wanting to block all URLs but 1.  I went through all the steps of creating the ID, decrypt, and access policies, but it does not seem to be applying. Then I noticed that if I go into the logs I see zero HTTPS entries even though I clearly have went to quite a few just in the last few minutes.  So now I am wondering if for some reason HTTPS is not being blocked at all, and sure enough, every HTTPS website is accessible. I did not set this up, and honestly have little WSA experience. Is there a known reason why this would happen?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Trying to block all but 1 URL

Hi 

 

1. You may create a custom URL category.

2. Define an identity policy and link the custom URL category with this identity policy.

3. Link custom URL category with decryption policy - allow or decrypt as per requirement.

4. Link custom URL category with access policy and configure allow access.

 

Regards,
Ashish Varghese
*** Rate All Helpful Responses ***

1 REPLY 1
Cisco Employee

Re: Trying to block all but 1 URL

Hi 

 

1. You may create a custom URL category.

2. Define an identity policy and link the custom URL category with this identity policy.

3. Link custom URL category with decryption policy - allow or decrypt as per requirement.

4. Link custom URL category with access policy and configure allow access.

 

Regards,
Ashish Varghese
*** Rate All Helpful Responses ***