Viten Patel is working as Technical Marketing Engineer (Converged Access) at Cisco. He was working as Wireless Escalation Engineer - Cisco TAC and holds many wireless certification like CCIE Wireless, CCNP Wireless, CCNA Wireless, CWNA, CWSP, CWAP, CWNE#146.
This document explains about the Prime Infrastructure WorkFlow for Converged Access. There are 3 WorkFlows (Small network, Large network and Centralized network deployment). This section shows the single switch Small Branch flow.
Below is a reference topology and deployment scenario
The WorkFlow helps deploy the above mentioned features. With just a few clicks you can deploy multiple branch networks with all the wired / wireless best practices for Converged Access.
What is achieved?
Some of the benefits of using the WorkFlow includes --
Simple to use
Masks the configuration complexity
covers most of the deployment scenarios
configure onces, use many times model
intelligence and best practices inbuilt in the tool
Hi All,I'm trying to setup Cisco 9800-CL (in VMWare) as primary (Foreign controller) and Anchor (In DMZ). I have completed the primary controller configuration and got the WAPs joined and working as expected for Flex-connect (locally switches vlans), but ...
I have the need to extend my wireless signal outside for about 100ft until a mesh wireless is install. I still have lightweight 3502i installed, can i reconfigure another LW3502i as a repeater have to rooted to the closest AP to extended just one SS...
I have a question on the reset of the Cisco Wireless Controller via the GUI interface. Will this only reconfigure the Wireless controller and leave the rest of the switch configuration in place? For some odd reason when changing this from a Mobility Contr...
Hey Folks, What will happen when two nos. of AP's (IW6300's) are placed side by side, may be 5 meters far from each other as Root access points communicating with other MAP's in the vicinity.In short, can those RAP's act as redundant access points to...