The session timeout parameter can be changed in WLAN > Edit. By default the session timeout parameter is configured for 1800 seconds before a reauthentication happens.
It is possible to change this value to anything, for example, it can be set to 180 seconds in order to make the client reauthenticate after three minutes.
Note: Sometimes a change in the session-timeout does not take effect. If this happens, try to upgrade the controller.
Also, check to see if the RADIUS Server (ACS) is configured for the same timeout value. The RADIUS attribute 27 is used in order to configure the session-timeout values.
In order to set this, choose user/group setup > Edit Settings > Radius[5842\001], and type the session timeout value in the Cisco-Aironet-Session-Timeout box. If this attribute is not listed under user/group setup, choose Interface config > Radius (IETF), and check the attribute  Session-Timeout for user/group.
One of the goals of the virtual interface on a WLC is to attend DHCP requests, the IP of this virtual interface must not be pingable but is used for DHCP requests... and from clients perspective the virtual interface address is the DHCP server ip address....
Community Live video- Popup Hotspot Using ISR 1000 with WiFi/LTE for Teleworkers and Micro Branches
(Live event - formerly known as Webcast Thursday 28 May, 2020 at 10 am Pacific/ 1 pm Eastern / 7 pm Paris)
This event had place on Thursday 28th, May 2020 ...
we're set up an environment for WIFI auto-connection,but met "802.1x 'txWhen' Timer expired for the station", could anyone help me to check the log what happened?please refer to the attached file for detail.thanks.
Hi allI have 2x newly installed AIR-AP1562I-E-K9 that won't join a 5508 controllerI have added AP MACs to the "AP Policy" section of the web interface (never had to do that before for other APs) "debug capwap errors enable" gives the following (not v...
Hi Team,Need your inputs on the below query. I need to upgrade the code on 3504 in HA mode to 8.5.161 from 8.5.135.Please ensure if the steps below are good to upgrade code without breaking the HA.1. Save current config. Copy the 8.5.161 image from T...