How to update Access Point firmware using TFTP when it is not possible to perform update through the HTTP interface.
Using the HTTP method to upgrade the firmware does not always work. In those cases, the best option is to use the TFTP method which is telnet. The TFTP method is more stable and can also help in circumstances where the Access Point (AP) firmware is to be overwritten due to shortage of Flash memory.
To upgrade the firmware through TFTP, perform these steps:
Extract and install the TFTP server software.
Copy the downloaded image file for AP in the same directory where the TFTP is installed. To verify that the image is in the correct location, click on the Show Dir button, and verify that the image is listed along with other files.
On the Telnet session of the AP, type this command:
Make sure that the /etc/services file contains this line:
Note You must restart the inetd daemon after modifying the /etc/inetd.conf and /etc/services files. To restart the daemon, either stop the inetd process and restart it, or enter a fastboot command (on the SunOS 4.x) or a reboot command (on Solaris 2.x or SunOS 5.x). For more information on the TFTP daemon, refer to the documentation for your workstation.
Ensure that the access point has a route to the TFTP server. The access point and the TFTP server must be in the same subnetwork if you do not have a router to route traffic between subnets. Check connectivity to the TFTP server by using the ping command.
Ensure that the configuration file to be downloaded is in the correct directory on the TFTP server (usually /tftpboot on a UNIX workstation).
For download operations, ensure that the permissions on the file are set correctly. The permission on the file should be world-read.
Before uploading the configuration file, you might need to create an empty file on the TFTP server. To create an empty file, enter the touch filename command, where filename is the name of the file you will use when uploading it to the server.
During upload operations, if you are overwriting an existing file (including an empty file, if you had to create one) on the server, ensure that the permissions on the file are set correctly. Permissions on the file should be world-write.
Downloading the Configuration File by Using TFTP
To configure the access point by using a configuration file downloaded from a TFTP server, follow these steps:
Step 1 Copy the configuration file to the appropriate TFTP directory on the workstation.
Step 2 Verify that the TFTP server is properly configured by referring to the "Preparing to Download or Upload a Configuration File by Using TFTP" section.
Step 3 Log into the access point through a Telnet session.
Step 4 Download the configuration file from the TFTP server to configure the access point.
Specify the IP address or host name of the TFTP server and the name of the file to download.
Hi all, My WLC AIR-CT3504-K9 is broadcasting several SSIDs for different purposes.I know it's possible to block specific machines from connecting to any of my ssid that is broadcasted from my WLC by blocking their mac addresses via "security->...
Hello All,I am newbie here, And I realy need help with one thing.We have new C9117 AP and C3504 WLC, We have setup 3504 with no issues, but having trouble connecting C9117 AP to it.this is message we get from APPS. Need to mention that we have added Licen...
I have a WLC 5508 version 8.5.135 my access point is 3802i. The access points are connected to a 9300 switch with POE +. I have 4 access points connected but my access points constantly restart physically change color (red, green)and from the WL...
Good Day, I am currently trying to load a new SSL Cert onto a WLC5520 but have been met with the following error each time: I have followed the steps for this from: https://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-la...