Hi everyone,
I just upgraded an appliance 1112 from ACS 4.0 to 4.2 followinf the Cisco upgrade guide
I got the message showing upgrade is OK but I could not connect to the device :
Cisco Secure ACS: 4.2.0.124
Appliance Management Software: 4.2.0.124
Appliance Base Image: 4.2.0.107
Status: Appliance is functioning properly
The ACS Appliance has not been configured.
Logon as 'Administrator' with password 'setup' to configure appliance.
But the prompt "login:" never appears... I plug the appliance to a switch that provide an DHCP address, so I could connect to the GUI interface but there is no gui admin login enabled. I reboot the appliance several times with no success, I still get this message but no prompt !!
I'm stuck with this issue does anyone have any solution to help me ?
Thank you