A repeater access point (AP) can be set up to authenticate to your network like other wireless client devices. After a network username and password is provided for the repeater AP, it authenticates to your network using Light Extensible Authentication Protocol (LEAP). LEAP is Cisco's wireless authentication method, and receives and uses dynamic Wired Equivalent Privacy (WEP) keys. On the repeater access point, you must enable the same cipher suite or WEP encryption method and WEP features that are enabled on the parent access point.
Access Points configured as Repeater APs support:
Cisco Extensible Authentication Protocol-Flexible Authentication via Secure Tunneling (EAP-FAST)
Wi-Fi Protected Access-Pre-Shared Key (WPA-PSK)
Note: Repeater access points support only the native VLAN. You cannot configure multiple VLANs on a repeater access point. Also, Repeater access points do not support wireless domain services (WDS). Do not configure a repeater access point as a WDS candidate, and do not configure a WDS access point to fall back to repeater mode in case of Ethernet failure.
It would be great if anyone explained why we get these errors on the Cisco Wireless controller. *dot1xMsgTask: May 31 00:04:14.261: %DOT1X-3-WPA_SEND_STATE_ERR: [PA]1x_kxsm.c:1718 Unable to send EAPOL-key msg - invalid WPA state (0) - client MA...
This is what Cisco book says about PAC phases:.....Phase 0: The PAC is generated or provisioned and installed on the client Phase 1: After they authenticate each other, they will negotiate a TLS tunnel....What will be installed on the client in phase...
I have checked the telnet / ssh function in the global settings. And global configuration is selected in the AP's advanced configuration page. Now I can ssh to all APs successfully , but I cannot telnet to all APs. The network between ...
So I have been given one of these after a store upgrade that I've been working on, Im quite IT literate and I can console into devices but without guidance this is where my knowledge stops, I want to use this AP for home use, when I plug it in, I get a co...