AP not join controller

[athan1234]

Hello

This AP was working fine a week ago. For some reason, the Ap is not JOIN to the controller.

Do you have any ideas?

(Cisco Controller) show> sysinfo

Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 8.0.133.0
Bootloader Version............................... 1.0.20
Field Recovery Image Version..................... 7.6.95.16
Firmware Version................................. FPGA 1.7, Env 1.8, USB console 2.2
Build Type....................................... DATA + WPS

[athan1234]

Is it usual that the mac address is different?

[Flavio Miranda]

AP has more than one mac address. It have the ethernet mac address and the radio mac address.

[athan1234]

HI @Flavio Miranda  Ok i am going to erase but not erase

capwap ap ?

controller lwapp primary controller
daisy-chaining daisy-chaining enable/disable
dot1x Configure the dot1x username and password
ethernet Configure ethernet parameters like vlan tag id
hostname Configure ap hostname
ip lwapp ap ip command
log-server Configure the syslog server where all LWAPP errors will be logged
mode Configure an AP mode
preferred-mode capwap mode of operation ipv4 or ipv6
primary-base Primary Controller
primed-timer primed-timer enable/disable
secondary-base Secondary Controller
tertiary-base Tertiary Controller

[Flavio Miranda]

You can do it from the WLC with the command

clear ap config <ap-name> keep-ip-config

[athan1234]

I cant see the ap on the controller

[Flavio Miranda]

Oh my bad!  Do you speak Portuguese ?

[Daniel Ordóñez Flores · Accepted solution]

Hello @athan1234 

you can try with "capwap ap mode local" from the AP

[athan1234]

 So thanks @Flavio Miranda  and @Daniel Ordóñez Flores