Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI AllI have enabled installed and Eval licnese and enabled FCoE on a nexus 5548 however I dont have the expected fcoe subcommandswhen i run fcoe ? i get the following:*** No matching command found in current mode, matching in (config) mode *** fcf-...
Hi AllIs anyone aware of a formula (or have their own) that can be applied to calculate the actual speed of a link?e.g. 10gb Port Channel between Chassis and FI or 16gb FC Port Channel from FI to Nexus 5k, what it the actual throughput?Or has anyone ...
Hi AllI am going to modify the chassis discovery policy in UCS environment (6248 FI's and 5108) and need some clarification. Each FI is cabled with 2 links to each FEX and I want to change the Chassis/FEX Policy from 1 link to Port Channel.What I nee...
Hi allI have a straightforward setup, NAtive FC portchannel from FI to N5k to NEtapp.THis all works fine as Blades are booting off LUN and can see their data LUNs.However when I run lunlist on an adpater I get no output...here is the ouptu on thet Ne...
Hi allI have 2 FI's connected via FC port channel to Nexus 5k;s which connect via port channel to Netapp controllers.On the NetApp's I can see that the hba's of the blades are logged in on vtic (boot lun's - and yes blades are booted and active)while...
Hi MikeThanks for the info but I soon realised I was using the incorrect cliconfiguration guideroFrom: Michael Turner Sent: 28 April 2014 20:27To: Ronan PhelanSubject: Re: - no FCoE CommnadsCisco Communities <https://communities.cisco.com/>no FCoE C...
Thank youCurrently we only have FC cards in the Netapp controller, no CNA.Does this mean we can only implement redundancy at the blade level with 2 vHBA's each connect to different Fabric Interconnects?
