Fabric Interconnect lunlist command - no output

[ronanphelan]

Hi all

I have 2 FI's connected via FC port channel to Nexus 5k;s which connect via port channel to Netapp controllers.

On the NetApp's I can see that the hba's of the blades are logged in on vtic (boot lun's - and yes blades are booted and active)

while troubleshooting some hba's that are not logged in I then noticed that when I connect to a hba that is logged in and run the lunlist or login command no data comes back.... any ideas?

adapter 1/3/1 (fls):8# vnic
---- ---- ---- ------- -------
vnic ecpu type state   lif   
---- ---- ---- ------- -------
15   1    fc   active  4
adapter 1/3/1 (fls):9# lunlist 15

adapter 1/3/1 (fls):10#

Should I not see the LUN info from the NetApp controller here?

Many thanks

Ro

[micturne]

Hello ronanphelan,

This question is a little too specific and really belongs in one of our support specific communities.  I would recommend re-posting at one or both of the following communities:

https://supportforums.cisco.com/community/netpro/data-center

NetApp Support

-Mike

[ronanphelan]

Thanks Michael

From: Michael Turner

Sent: 11 December 2013 20:12

To: Ronan Phelan

Subject: Re: - Fabric Interconnect lunlist command

- no output

Cisco Communities <https://communities.cisco.com/>

Fabric Interconnect lunlist command - no output

reply from Michael Turner

<https://communities.cisco.com/people/micturne>in *Technology

Data Center & Cloud* - View the full discussion<https://communities.cisco.com/message/139316#139316>