设备：Nexus7000 C7010 ；N2K-C2248TP-1GE 光板卡：N7K-M132XP-12L，10 Gbps Ethernet XL Module 光模块：SFP-10G-SR 在N7K上看到对N2K的收光过大，为0.81dBm SFP Detail Diagnostics Information (internal calibration) --------------------------------------------------------------------------------- Current Alarms Warnings Measurement High Low High Low --------------------------------------------------------------------------------- Temperature 46.48 C 75.00 C -5.00 C 70.00 C 0.00 C Voltage 3.27 V 3.63 V 2.97 V 3.46 V 3.13 V Current 8.33 mA 11.80 mA 4.00 mA 10.80 mA 5.00 mA Tx Power -2.45 dBm 1.69 dBm -11.30 dBm -1.30 dBm -7.30 dBm Rx Power 0.81 dBm + 1.99 dBm -13.97 dBm -1.00 dBm -9.91 dBm Transmit Fault Count = 1 ---------------------------------------------------------------------------- Note: ++ high-alarm; + high-warning; -- low-alarm; - low-warning 在N2K上看到收发光都是正常的 SFP Detail Diagnostics Information ---------------------------------------------------------------------------- Alarms Warnings High Low High Low ---------------------------------------------------------------------------- Temperature 29.48 C 75.00 C -5.00 C 70.00 C 0.00 C Voltage 3.29 V 3.63 V 2.97 V 3.46 V 3.13 V Current 7.20 mA 10.50 mA 2.50 mA 10.50 mA 2.50 mA Tx Power -2.29 dBm 1.69 dBm -11.30 dBm -1.30 dBm -7.30 dBm Rx Power -3.19 dBm -- 1.99 dBm -13.97 dBm -1.00 dBm -9.91 dBm Transmit Fault Count = 0 ---------------------------------------------------------------------------- Note: ++ high-alarm; + high-warning; -- low-alarm; - low-warning 我的疑问： 1.N2K上发光是-2.29，N7K收光是0.81，这光衰还往正数方向增大？ 2.N2K上收光-3.19，明明没有超过Warnings的High与Low值，但为什么会出现- -的low-alarm告警？难道是BUG？而且有些正常端口存在- -的low-alarm告警，有些正常端口又没有- -的low-alarm告警
