Cisco DNA Center Installation Guide

[gunheon103]

When installing Cisco DNA Center, is there a case where the DNA Center equipment GUI is not accessible after the installation process is finished without a cluster interface?

[balaji.bandi]

is this single DNAC Installation ? hardware or virtual ?

check maglec status of packages ( DNAC take some time to get all the packages install) - make sure you using right interface to connect to DNAC

maglev package status

check installation guide :

https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/2-3-5/install_guide/2ndgen/b_cisco_dna_center_install_guide_2_3_5_2ndGen/m_configure_appliance_mcw_2_3_5_2ndgen.html#task_tdr_ltj_sfb

[gunheon103]

It is hardware and recently installed without requiring a cluster interface, but after the installation was complete, an error appeared in the GUI and was not accessible.

I'm planning to reinstall it later. Thank you.

[balaji.bandi · Accepted solution]

Make sure what hardware you have and check the version of DNAC you installing.

[gunheon103]

After installing DNA C, I found that it takes time to access the GUI.
Currently, it can be used right away without a reinstallation process.