09-23-2021 04:08 PM
Hello all,
On one of my leaf switches I have run the command debug system internal epm trace detail which I guess sets a debug level on the leaf. Is there a way to "undebug" or "no" this command to turn it off now that I'm done with it? I can't seem to find any documentation on the Cisco ACI Leaf debug levels or how to "undebug" commands like the above.
Thanks!
Solved! Go to Solution.
09-23-2021 04:46 PM
Hopefully you enabled the debug via vsh command. If so, you can disable it with:
vsh -c "debug system internal epm trace default"
Robert
09-23-2021 04:46 PM
Hopefully you enabled the debug via vsh command. If so, you can disable it with:
vsh -c "debug system internal epm trace default"
Robert
09-23-2021 05:46 PM
@Robert Burns I was following this Cisco .pdf presentation which actually has you run it at the regular leaf1# prompt and also via vsh_lc -c , but nothing with vsh.
Will running the vsh command above work if I ran the debug command at both of the above prompts?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide