07-03-2019 12:47 AM
ACI 4.1(1L)
I have a fabric where I added a spine and leaf for a short time and then decommissioned/removed said switches.
While present, some faults were raised on the switches and did not clear when the switches were removed. I do not see it listed under registered nodes, nodes pending registration, unreachable nodes, nor decommissioned switches.
How does one clear faults associate with non existant switches?
F1295
minor
Raised
topology/pod-1/node-1002/local/svc-policyelem-id-0/uni/fabric/time-default/issues
Fault delegate: Datetime Policy Configuration for default failed due to : provider-is-not-present-under-default-pol
Config
configuration-failed
configQual:provider-is-not-present-under-default-pol, configSt:failed-to-apply
F1700
minor
Raised
topology/pod-1/node-1002/sys/time
Fault delegate: Ntp configuration on spine SP1001 is Not Synchronized
Operational
protocol-ntp-sync-failed
07-03-2019 01:41 AM
Hello,
Try to ignore the Fault for one minute.
To do so, right-click the Fault and "Ignore Fault". Then revert the change by finding the created Fault Severity Assignment Policy and deleting it.
Check if Fault is still there.
Remi Astruc
07-03-2019 08:43 AM
This did not have an impact. Had the faults suppressed for upwards of 6 minutes.
Thank You,
Dan Laden
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide