05-02-2022 02:23 PM
Hi, I need to configure L3out using OSPF between ACI Border Leafs and VSS (virtual switch system). Idea is to connect them with a 4 x ports back-to-back VPC (or MEC in the VSS terminology) and then use sub-interfaces on the PO level. (Diagram attached).
Just checking if this is a supported design?
Solved! Go to Solution.
06-05-2022 11:14 PM
Hello,
This seems to be a valid configuration from the ACI perspective (a device connected with vPC to a L3Out and running a routing protocol with ACI) and if VSS MEC matches the L2\3 configurations similar to ACI, this must be feasible.
P.S. I am not aware if Cisco engineering has tested this configuration and support the same.
06-05-2022 11:14 PM
Hello,
This seems to be a valid configuration from the ACI perspective (a device connected with vPC to a L3Out and running a routing protocol with ACI) and if VSS MEC matches the L2\3 configurations similar to ACI, this must be feasible.
P.S. I am not aware if Cisco engineering has tested this configuration and support the same.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide