06-25-2019 02:25 AM
Hi
Is there a official Best Practice Example available for monitoring APIC´s .
For Example:
Use for hardware purposes only the CIMC IP and for ACi Fabric Related Stuff only APIC OOB IP ?
Why I am asking is I can not monitor the Harddisk Status via SNMP if i use the APIC OOB IP .
How do you monitor a UCS C220 for Power Supply status , HDD , Memory , etc. ??
Regards Markus
06-25-2019 03:46 AM
Hi Markus
Have a look at these -
Rergards
06-25-2019 03:57 AM
Hi omz
Could you please help me where i have to find the information about HD status , HD errors etc. unter this link.
regards Markus
06-25-2019 07:15 AM
Hi Markus
I cannot see HDD/Storage under MIBs Supported by APIC -https://www.cisco.com/c/dam/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/mib/list/mib-support.html
I think you have to use the UCS MIB from storage info polling.
ftp://ftp.cisco.com/pub/mibs/supportlists/ucs/ucs-C-supportlist.html
06-25-2019 10:35 PM
Hi omz
That MIB
ftp://ftp.cisco.com/pub/mibs/supportlists/ucs/ucs-C-supportlist.html
is to use with the CIMC right ?
That would mean i can not monitor a APIC with only one IP Address to get all the needed informations to check the heath Status ?
You always need to snmp poll the APIC and the CIMC IP to get all informations about the health status
Regards Markus
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide