MSO Site IP Addresses

[alanjames9]

Hey Guys,

I'm looking at staging two ACI sites with multi-site orchestrator (MSO) at a single location.  I only have access to one management network, so I will re-ip address the management interfaces of the 2nd DC ACI APICS to be in the new management network after i move them.  But, its it possible to change the IP Address of the sites within MSO? would this cause any issues with the MSITE or Tenant configuration?

- Thanks

[Sergiu.Daniluk]

Yes, the IP addresses of APICs can be changed for a Site. You can do it from: Sites > SiteName > APIC Controller URL

I never tested the change, but I think there shouls be no impact on existing  config.

Stay safe,

Sergiu

[Robert Burns]

No issues changing the APICs IP.  After you do, just refresh the Site data and should be no other impact assuming nothing in the Schemas have been changed.

Robert

[alanjames9]

Thanks!

Is it possible to change the management IP Address of two of three MSOs as well?

I was wanting to deploy all three MSO images to a single VMHost (non-case)  then move two VMs to a new host in a different data centre.