07-25-2021 11:57 PM
Hi ACI board,
I integrated a standby APIC into my fabric.
When using the command "show controller" on a APIC within my fabric, the standby APIC is listed in the output with the status "data-layer-partially-diverged".
Is this the normal behavior? Can anybody check if this is the same in another fabric?
SW version is: 4.2(7f)
Solved! Go to Solution.
07-29-2021 03:02 AM
Hey Robert,
thank you for your reply. In the meantime I opened a TAC case for this and this is obviously a cosmetic issue (CSCvx89970)
07-26-2021 05:47 AM
Did you "accept" the APIC (from your other post)? Once you Accept it the cluster will bounce through Fully-Fit & Partially-Diverged states until they're all sync'd up. Shouldn't take more than an hour typically. If it takes longer, you have an issue. I assume the Standby APIC was already imaged to the exact same APIC software version as the other controllers?
Robert
07-26-2021 07:13 AM
Hey Robert,
the first step I did was to reinstall the APIC from ISO with the same SW version as the other APICs (4.2(7f)).
So the standby APIC is "accepted" and all, but it's still in "data-layer-partially-diverged" state since this morning. In the web UI I don't see any faults or anything. It's just when checking the CLI using the "show controller" command.
Guess I have to open a TAC case for this. Or do you know any command to get the root cause for this?
07-26-2021 07:26 AM
Can you gather the following outputs from one of your Active APICs CLI (log your SSH session output to a file):
Attach output file here.
Robert
05-17-2023 08:37 PM
Wait 20 minutes and the controllers synced
07-29-2021 03:02 AM
Hey Robert,
thank you for your reply. In the meantime I opened a TAC case for this and this is obviously a cosmetic issue (CSCvx89970)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide