08-08-2012 08:45 AM
We are converting an old CSS LB to a new ACE. Since the old CSS was in a one armed config and our application used custom port numbers I need to know how to have the ACE load balance to a server using non standard ports.
Here is example.
3 servers, server A uses port 20000 server B uses port 20001 server C user port 20002
each server is on its own ip address
08-08-2012 11:05 AM
Hi,
Here is the sample config for one arm mode.
for custom port numbers, make sure you configure specific ports under rserver
serverfarm host custom
rserver A 20000
inservice
rserver B 20001
inservice
...
Regards,
Siva
08-08-2012 11:36 AM
Hi,
Something which you should take into account that when you have a serverfarm with different servers hearing on different, it might be possible that the requests can be sent to a server which hears on "another port", then it is better to have everything separated
serverfarm host 20000-services
rserver service1 20000
inservice
rserver service2 20000
inservice
serverfarm host 20001-services
rserver service3 20001
inservice
rserver service4 20001
serverfarm host 20002-services
rserver service5
or even something like this:
serverfarm host 20001-services
rserver server1 20001
inservice
rserver server2 20001
inservice
serverfarm host 20002-services
rserver server1 20002
inservice
rserver server2 20002
inservice
Hope this helps
Jorge
08-08-2012 11:53 AM
Yes it does, thank you. Exactly what I was looking for
Dave
08-08-2012 12:32 PM
It sounds great.
Jorge
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide