The ACE module in SPB 6509 rebooted at 7:23pm. This ACE supports our main applications that you know at this time is extremely busy with inmate release going on.
The error was: last boot reason: NP 2 Failed : NP Process Crashed
configuration register: 0x1
ACE-HUB kernel uptime is 0 days 1 hours 49 minute(s) 0 second(s)
The only information I found out in reference to this error is a bug in the IOS, which now is not a good time to upgrade the IOS either.
This is end of life and end of support through Cisco.
I found the first ACE we used in our previous data center, same model.
My question is can you configure an ACE module as a failover such as FW failover?