Hi All,We are in the process of supporting our client moving off out of support hardware, and one of the devices they are still using ACE 4710-K9s.There is a very pressing problem, they are running old firmware levels on the existing equipment that d...
Forum Posts
Resolved! WAP Bandwidth monitoring in DNAC
Good afternoon all,Is there a way for me to be able to monitor the bandwidth usage on our APs using DNA Center
Hi , we have one WAAS with dual power supplies, but the recently the WAAS rebooted frequently, and run show version and can see the reboot reason is "power-on" . Anyone can please advise whether it means the power issue or not? thanks in advance.
Resolved! Cisco Prime infrastructure 3.2
hellowe have prime infrastructure 3.2 physically installed on Cisco UCS C220 M4 Servermy question is how to migrate this appliance to a virtual applianceyhanks
ip routing is not working in ws-c3560g-24ps with IOS version 12.2 (50) se5 where SW image: "c3560-ipbase-m" is being used. If we use ip routing and set a default route we can not access the switch from different subnets. But when we stop "ip routing"...
We have two data centers connected with only OTV link. All the network traffic flowing (extended vlans) are passing through OTV. We need to make L3 routing for few subnets which are configured on aggregation switches on both sites. How can we achieve...
I have a error show cms info after DISK exchange and run disk recreate-raid and reload commandWhat is the meaning of it? And how to fix it?below some informations.thanks a lot for support.rmdwoc11#show cms infspawnp: execve: : No such file or directo...
Hi, We have a Cisco Nexus 9300 (VXLAN fabric) connected directly to a Data Port of a Cisco NAM. We have configured a ERSPAN session on both devices but Cisco NAM does not detect ERSPAN traffic on Data Port 1. Switch configurationinterface Ethernet1/...
Sir,I am using 2 numbers of sg 550 as core switch and sg 350 as client switches in different floor.. here 2 core switch is used as redundancy.. the core switch is placed in first floor have 4 access switch. The second floor have 2 access switch. And ...
Hi I have just completed my first OTV setup which is working as expected. I have 2 sites each with 2 x ASR routers on a stick setup. Not sure if this an issues or not but at one of the sites when i do "sh otv vlan" one of the ASR states is showing as...
The ACE module in SPB 6509 rebooted at 7:23pm. This ACE supports our main applications that you know at this time is extremely busy with inmate release going on. The error was: last boot reason: NP 2 Failed : NP Process Crashed configuration regis...
Resolved! SSH CONFIGURATION
hi everyone i am setting up a lab on cisco packet tracer to create an access via ssh. I created both a dns server (from which the encryption keys will be generated via ssh), two PCs and a switch in the center. On the switch I configured the vlan 1 (t...
Hi Is there another portal customers can use to verify what a part is. I am conducting an inventory and found some devices that I need to identify either a line card or just a chassis part. I signed up to this community but this for support so I was ...
Hi, is it possible to restrict an SNMPv3 user to access certain MIBs?
Just followed the document "Cisco DNA Center Second Generation Appliance Installation Guide, Release 1.3.3.0" to configure the DNAC appliance. It appears to have been succesful & i can ping the mgmt & enterprise interface & i can access the CIMC inte...
