ACE rate limiting per source

[zhenningx]

Hi, is there a way to configure ACE to perform rate liimting per source address? Say if a source sends more than 100 connections per second, I want ACE to drop further connections from this perticular source only.

thanks.

[Nicolas Fournier]

Hi,

Unfortunately this is not possible on the ACE module at the moment.

You might be able to achieve something similar though by using the UBRL feature on the catalyst itself:

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/prod_white_paper0900aecd803e5017.html

Regards,

Nicolas