09-25-2014 09:02 AM
Hi,
I have two ace module in ha mode, each ace are inside of a catalyst 6509, the catalyst are in vss mode.
Iam going to install another vss with two ace module, I would like to know if is possible to configure the four ace module in ha mode?
Regards
Fidel Gonzalez
Solved! Go to Solution.
09-25-2014 09:18 AM
Hi Fidel,
There can be FT redundancy between only two ACE's at a time. You cannot have 1 Active and 3 standby. It is not supported. But you can have two ACE modules in a single chassis acting as active-standby or in different chassis.
Regards,
Kanwal
Note: Please mark answers if they are helpful.
09-25-2014 09:18 AM
Hi Fidel,
There can be FT redundancy between only two ACE's at a time. You cannot have 1 Active and 3 standby. It is not supported. But you can have two ACE modules in a single chassis acting as active-standby or in different chassis.
Regards,
Kanwal
Note: Please mark answers if they are helpful.
09-25-2014 09:38 AM
Hi Kanwalsi,
Thanks you for the quick answer.
Regards,
Fidel Gonzalez
09-29-2014 12:42 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
Hi Fidel,
You might want to check out this new product called ITD.
Simple and faster solution:
ITD provides :
Blog
At a glance
ITD config guide
Email Query or feedback:ask-itd@external.cisco.com