09-25-2014 09:02 AM
Hi,
I have two ace module in ha mode, each ace are inside of a catalyst 6509, the catalyst are in vss mode.
Iam going to install another vss with two ace module, I would like to know if is possible to configure the four ace module in ha mode?
Regards
Fidel Gonzalez
Solved! Go to Solution.
09-25-2014 09:18 AM
Hi Fidel,
There can be FT redundancy between only two ACE's at a time. You cannot have 1 Active and 3 standby. It is not supported. But you can have two ACE modules in a single chassis acting as active-standby or in different chassis.
Regards,
Kanwal
Note: Please mark answers if they are helpful.
09-25-2014 09:18 AM
Hi Fidel,
There can be FT redundancy between only two ACE's at a time. You cannot have 1 Active and 3 standby. It is not supported. But you can have two ACE modules in a single chassis acting as active-standby or in different chassis.
Regards,
Kanwal
Note: Please mark answers if they are helpful.
09-25-2014 09:38 AM
Hi Kanwalsi,
Thanks you for the quick answer.
Regards,
Fidel Gonzalez
09-29-2014 12:42 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Hi Fidel,
You might want to check out this new product called ITD.
Simple and faster solution:
ITD provides :
Blog
At a glance
ITD config guide
Email Query or feedback:ask-itd@external.cisco.com