Hi Guys,
This would seem trivial however I can't seem to set the appropriate timezone as indicated below:
Trying to set the timezone on our ACE30 modules (running A5(1.2):
clay1-ace/Admin(config)# clock timezone AEST +10
^
% invalid parameter detected at '^' marker.
clay1-ace/Admin(config)# clock timezone AEST ?
<-23-23> Hours offset from UTC
I cannot use the "standard" word because the ACST time would leave us 30mins out.
On our 3750 switches the following command just works;
clock timezone AEST 10
According to the Cisco documentation:
clock timezone {zone_name{+ | -} hours
hours — Hours offset from UTC. The range is from -23 to +23.
However I can't seem to set the hours as "+10"?
Thanks
Sheldon