Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
We have farily stock standard config across our 5Ks as follows however while the port-channel / vPC is UP the server side complains with the following error continiously:
dc-224-dh3-rke17-sas1
interface port-channel644 switchport mode trunk...
Hi Guys,
On our 6500s we often use the "ip helper-address" command for PXE boot scenarios. However when trying to configure the same command on the Nexus7K platform we've observed that the command isn't available, but rather : ip dhcp relay address,...
Hi Guys,
Quick question - can rate-mode dedicated be configured across any ports on the N7K-F248XP-25 module? The Cisco doco isn't all that clear. I've read here that the modules being F2 modules have fabric capacity of up to 480Gbps:
https://learn...
Hi There,Wondering if Cisco have a tool to convert 3750 QoS config to 3850 QoS config? We are about to roll out 3850 switches and are in the process of converting our running config template, and such a tool would be handy. At the moment I'm readin...
Hi Guys,We are running the following code on our MDS 9500s SUPs:kickstart variable = bootflash:/m9500-sf2ek9-kickstart-mz.4.2.1b.binsystem variable = bootflash:/m9500-sf2ek9-mz.4.2.1b.bin According to Cisco's EOL notice the only version mentioned is ...
Hi There,I tried that as well though and it doesn't work unfortunately. If you issue "Upto_TLS1.2" and then "no version SSL3", it removes any previous version configured altogether, i.e. it removes Upto_TLS1.2. Any other ideas from CIsco personnel t...
