Hi,
Is it all possible to use an ACE30 to RHI a VIP which acts as route for servers on LAN A to reach LAN B . We have 2xL2 WAN circuits between 2 sites used by only 4 servers for (different L3 subnets for the hosts). I`m considering using a VIP to load balance across 2 WAN circuits using L3 interfaces on the MSFC either side as rservers with a single VLAN in/out on the ACE where the VIP resides - simlair to using the Cisco design for firewall load balancing minus the inspections etc. Obviously we can do this entirely in the MSFC but considering options.
Thanks