Application Networking

I'm trying to setup a service to load balance two servers that will permit Network scanning from a Xerox device. When I set it up it appears to hang on the Netbios name.I have the content protocol set for any.How do I resolve netbios name on a CSS? D...

Hi AllWe have 2 x WAE-674 (V4.4.1) and would like to deploy the WAE's as a Cluster in a single site/DC.How do we go about setting this up?ThanksZubair

I have a wildcard cert installed on my ACE and a HTTP redirect for any http traffic.  The redirect works fine for all http traffic and HTTPS traffic.  I am recieving an error when users try to connect to https://domain.com.  If they connect to Https:...

Hi my name is IvanI have a wan betwen two sites, and i'm going to work waas with wae core, edge and central manager, in main site i have 1MB of bandwith and the remote site i have 512kb of bandwith. Please colud you tell me and advice to choose betwe...

If I want to change the IP of my Central Manager, is it just a case of changing the IP and all will work?

Hello,We are using an ACE20 module running version A2(3.2).I have a question regarding IP stickyness and the timeout parameter.I found this in the "Server load balancing configuration guide" (in a section entitled: "Configuring a Timeout for IP Addre...

Hello,for the ACE module I did not find an easy way to create a backup for the whole configuration (running configuration and crypto material of all the contexts). Any ideas? I only found a perl backup script for Cisco ASA which I could modify:http:/...

HiI need configure HTTP Compression by hardware on CSS 11503. I make config like this http://www.cisco.com/en/US/docs/app_ntwk_services/data_center_app_services/css11500series/v8.10/configuration/ssl/guide/Compress.html#wp1031247My config:service s1 ...

How can i configure Ace to stick to ASP.NET_SessionId value?is it cookie layer-4 payload or http-header?I cannot find any good examples how to use advanced sticky config (layer-4 etc).Thanks.

I need to add a second port to a class-map, so I need to change it from match-all to match-any.  Do I just remove the old virtual server and re-add it?   no class-map match-all vs_test class-map match-any vs_test                                      ...

HelloI'm seeing the following services disabled on a WAE-574 device (4.4.1). This started happening after replacing a failed hard disk. I tried doing a disk delete-data-partition but I'm still getting the alarms below. How can I restart the nodemgr s...

Here are the first lines of output from a Cisco script that finds files in the cifs folder:KQPGXTF#script execute cifsdir-new.shDirectory: drwxrwxrwx 4 admin root 4096 Dec 30 17:34 /obj1/data/cifs/ls: drwxrwxrwx: No such file or directoryls: 4: No su...