Application Networking

Hi ,I need some advice on how to start troubleshooting on one the issue on ACE. I am new to ACE/Load balancers.The application if is bypassed ACE , it works fine . When it is accessed through the ACE the application timeouts.Any help will be apprecia...

IGMP Snooping configuration for Multicasting on Cisco Catalyst 3020Hi Guru,Our switch model is "Cisco Catalyst Blade Switch 3020 for HP"We are building HA (High Availability) Databases infrastructure.Currently, there are two nodes(hosts- servers) and...

Hi guys,I am load balancing Terminal Server Windows 2008 sessions with an CSS 11501. The code version is sg0750004 (07.50.0.04).I am trying to establish a Terminal Server session with Single Sign-On (SSO), but without success. Normal login with Usern...

I configured a basic SMTP probe but it is not working properly : all the rservers are failing and the 'show probe detail' command shows the configured probe receives an invalid status code.Here is a portion of the configuration :<<probe smtp PROBE_SM...

I have a problem with a the load balancing "not working" properly depending on the source.The load balancing decision is done with a secondary cookie (?ld=fe1 or ?ld=fe2). If it appears and the value is fe1 the request should go to serverfarm FE1-app...

Hello,I am attempting to set-up a WAAS service. In the data centre I have a router using PBR to route specific traffic to the data centre WAAS. The remote WAAS is using inline interface. All traffic will be SSH/SSL. Is there anything I should beware ...

We have an ACE 4710 providing load balancer functions for 2x websites.  Is there a way to set up a probe to look for an image on the homepage of the website to deem the site is available.Thanks in advance

I have a WAE-512-K9 configured as a WAAS Central Manager.When I turnet it on I get the meessage"CSCO chs dbgrub_start.S Uncompressing Linux... OK, booting the Kernel"and hangs on this screen.I've tried to boot the appliance from a Rescue CD downloade...

Have setup a new Owner/Service/Group for loadbalancing NTP traffic to 2 NTP servers. It all appears to work fine apart from failure of one of the servers NTP service. I've currently set up a simple ping keepalive which works fine if one of the server...

Hi,Can we use Same Nat pool for 2 different Server farms in CSM? Does it work. Or will it create any issue(For E.g)natpool XYZ  10.0.0.63 10.0.0.63 netmask 255.255.255.128serverfarm ABC  nat server  nat client XYZ   real name Real1   health probe TCP...

We are on 4.2.1 and I need to upgrade to support exchange 2010. All devices are in a group to control config other than time. Can I upgrade only the central waas and one other waas to test the upgrade? I have one waas remote at about 90 miles so I ca...

Hi All,Not too faniliar with Ciscos and have question.I currently have a content group as follows;content My_Groupadd service blade1add service blade2add service blade3vip address 1.2.3.4advanced-balance arrowpoint-cookiearrowpoint-cookie name davepr...

I have a serverfarm configured as follows:serverfarm host testfarm  rserver testserver1    probe http-test    inservice  rserver testserver2    probe http-test    inserviceBoth rservers have connections on them.  I would like to move the probe from u...