Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

Hi …I configured two Cisco load balancers (two ACE 4710 in active/standby HAV mode), to balance web requests on port 80 among two AS-10g Oracle application servers (OC4J).I am getting the following error when I try to access OC4J forms though Cisco A...

What is the Central Manager License used for ?I have 6 Sites. 1 DataCenter 1 DR Site and 4 Branches. At Datacenter and DR Site we have WAE-674 and at Branches we have NME-302 and NME-502.If I purchase Enterprise License for all products do we still n...

Hi,I am configuring failover on two ACE 4710 device using a dedicated interface (gig1/4) connected to a switch with same VLAN. Below are my ACE ft config:ACE1:--------Admin contextinterface gigabitEthernet 1/4  ft-port vlan 30  no shutdownft interfac...

winpwnkmr by Level 1
  • 1831 Views
  • 4 replies
  • 0 Helpful votes

I have a ACE 4710 which I have enabled compression on the L7 policy map using compress default-method gzip. We have recently run a performance test and I have noticed many compression errors on the show service-policy detail output. However I cannot ...

HelloI am attaching a script of a CSS 11503 with four services configured and one content either.  So, i am actually having problems with this configuration, because when all the services are active, it works perfect, however when one service goes do...

Hi,One of our WAE 274 inlinecard is in autosense mode but have diffrent speed on the LAN port "1000" and the WAN port "100", same duplex "full".Is this any issue, as there is no posibility to have diffrent speed and duplex on LAN/WAN?Jan Rockstedt

I ordered a WAE512 for one of our foreign companies. Now they got the appliance. i connected via console and detected that Cisco delivered ace512-5.5.15.2Now to my question:Is there a chance to migrate a Ce to WAE512. Including all of the required li...