Application Networking

Okay, here is what I have. I know that this may be under-spec'd, but it is what we have to try and make this work:Datacenter: (1) 512 for Central Manager(1) 512 as Core WAEBranch sites:(1) NMWAE-302 Here's the deal. All branch sites are connected o...

I have multiple sites with WAE's deployed for a DMS implementation. I have a standard multicast configuration that has been tested and applied to all remote sites. The config simply enables multicast routing globally and ip pim sparse mode on the r...

Hi,We have a pair of ACE modules running c6ace-t1k9-mz.A2_1_1a.bin. They are a redundant pair, one in each of two 6513s.A few weeks ago we had to reboot the active ACE as none of the load balanced services were working through it. We could access the...

Situation: a) two WAAS accelerated sites connect to an MPLS WAN with different speed links 4 mbps and 40 mbps subscribed bandwidth respectively.b) the deployment mode for both sites is in-linec) both appliances are WAE-512d) other sites connect to th...

How upgrade ACNS to WAAS?thank you

Hi Friend,I am facing UDP flows problem.When I enable flow-enable for DNS server use command "flow-state 53 udp flow-enable", after 2-3 hours the DNS service was not work well.Can not resolve some record from DNS server intermittently.CSS11501(debug)...

please see my CSS configure, it is a basic config, but CSS always divert the traffic to 10.122.70.13, even it is down, while 10.122.70.14 untouched:!************************* INTERFACE *************************interface 1/1 trunk vlan 25 vlan 70i...

Hello, I have been reading the Ace configuration manual and other resources but cannot find clear answers. I would like to clarify the Ace behaviour for the following please (or recommended reading):Q. How does the Ace handle connection establishme...

Hi All,I have a situation with my central manager. I have a project for about 200 branches and they purchased just one central manager. The problem now is that the central manager is corrupted. I cant configure it or even recover it because once i t...

Hello there, I hope that you can help me. I have a case with the TAC trying to solve this isssue, this is my topology:+---------+ +---+| ACE01 | | - |+---------+ -------- | - | SERVER 01+---------+ -+ +---- | - || 6500-01 | | | ...

I wonder if someone can tell me if the Cisco ACE 4710 Apppliance supports the following functions:1. IPv62. routing protocol such as OSPF, BGP or RIP3. Policy based routing or source routing

Hi All,I am not able to connect to a virtual IP address of ACE 4710 and either i am able to ping it. Kindly let me know if anything wrong here.Regards,Neha.