Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Im trying to redistribute some static routes into OSPF on a Cisco ASA 5520 running 8.2(2). I need to filter a few specific routes from being redistributed but I cant seem to use a prefix list with a route-map on ASA. Does anybody know how else to ac...
Is it possible to create a SIP trunk between CallManager v8.5.1 and v4.1 for 4 digit extension dialing between companies? Does anybody have any good writeup on how this is done or a pointer in the right direction?Thanks!
Can anybody tell me whether or not changing the standby ip of an interface on a Pix515e (7.2.2) will disrupt service or cause any problems?interface Ethernet1 speed 100 duplex full nameif inside security-level 100 ip address 192.168.17.5 255.255.255....
I have a HP Server that I want to setup to use an etherchannel for 2Gbs bandwidth. I keep having the same problem, one of the NIC's will only negotiate 100mbs/full and the other will negotiate the full 1000mbs/full. I have had this issue on 2 HP ser...
I have recently run into a problem with Oracle RAC and the amount of data that was being generated on the interconnect (between RAC nodes) connections. The interconnect links all happened to lie on the same port ASIC within a WS-X6548-GE-TX (Ports 1...
The Cisco documentation on this is sketchy (IOSXR 6.x) but I think everything in your first section is correct except for the part about LACP. With EVPN you dont need LACP, you can just use "on" mode on your DHD and set the the same ESI (Ethernet se...
Your post really helped me in a pinch, thanks for contributing you knowledge. I would have never know that services get disable after they fail a certain number of times and you have to re-enable them through the UCCX servicability tool. Thanks
Thanks for all your replies, I did try to hard set the speed/duplex but that only resulted in the network card thinking the cable was disconnected. I replaced all the network cables and tried "channel-group 2 mode on", all with no resolution. I upg...
