Application Networking

Hi All,In the network layout below, does the ACE need to be setup in a routed mode to work? can it be also be setup in a bridged mode in this scenario?Network Cloud <--> Firewall <--> ACE <--> Router <--> Server Farm.Any refences would also be greatl...

This is my Load Balancer CSS11503 configuration!*************************** GLOBAL *************************** no restrict web-mgmt cdp run ip route 0.0.0.0 0.0.0.0 10.138.78.34 1 ip route 10.0.0.0 255.0.0.0 10.138.78.33 1!************************* I...

Hi,I have two CSS that I use to load balance RDP connections to two WTS servers. I dont have switch behind CSS so they are connected back-to-back via cable. All server facing ports (including back-to-back ports) are in the same VLAN.CSS1 is primary f...

Hi,I have a requirement to do SSL transparent proxy for multiple websites sharing the same VIP. I want to use the host header information from the client to decide which certificate to use.I can't seem to find anything in the documentation on how to ...

Hi Sir,I'm configuring WAE-7326 & WAE-612. There are two Gigabit Ethernet interfaces: Gig 1/0 and Gig 2/0.What is the other interface typically used for? For e.g. my primary interface is Gig 1/0. What should I use Gig 2/0 for? I wish to use it to bac...

How exactly this command benefits permanent flows?

Is there a way to NAT a server initiated connection based upon destination similar to what's possible using a souce group in a CSS. What I'd like to do is NAT a server initiated connection to the Virtual IP when the server is connecting to the intern...

We have few servers whose default gateway is the load the balancer. Even though no services/VIP's configured for these servers they cross the Load balancer to access other networks..it was working fine until recently wherein these connections got dro...

Customer says CSS11503 is dropping packets to Firewalls.The troubleshooting steps are in the attached file.