Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,we're running a 2960 four switch stack, Version 15.2(2)E6, and yesterday it had just stopped communicating such as responding to pings, etc. Neither could we console in to see what's going on, but all the lights appeared to be green and it never l...
We have the following isakmp policy map on our ISR4331 router that we're using as a spoke: Global IKE policyProtection suite of priority 1 encryption algorithm: Three key triple DES hash algorithm: Secure Hash Standard ...
We have a bunch of remote sites that we would like to run DMVPN between and were wondering what type circuits we would need to order for these sites to be able to run DMVPN on top of? Thanks. _Greg
Hello,we have a WLC module on the router and it's using a sub interface for the wireless subnet, as in the following: interface Integrated-Service-Engine1/0.900 encapsulation dot1Q 900 ip address 10.1.10.1 255.255.255.128 ip helper-address x.x.x.x ...
sh switchSwitch/Stack Mac Address : 701f.5324.f480H/W CurrentSwitch# Role Mac Address Priority Version State----------------------------------------------------------*1 Master 701f.5324.f480 15 4 Ready2 Member 50f7.22d2.3b00 13 4 Ready3 Member 701f.5...
Thanks for your response..So, this stack had been up for awhile until it stopped responding yesterday, so all the cables were in place. Also, we were pinging the management address, which is on the master switch. Thanks. _ Greg
So, Cisco had to whitelist my public source IP address and I was able to pull the vmanage link for the Viptela device we have. However, I was not able to authenticate into that vmanage site with the same credentials I used for accessing the Viptela d...
Thanks for your response.We've gotten the FQDN URL from Cisco and did an nslookup on it and got the public IP address. However, we still couldn't pull the url. Is there anything else we need to be able to pull that url or its corresponding IP address...
