Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi GillesI have a one armed network configuration of my CSS. I had four web servers which are being load balanced. These web servers in turn connect to two billing servers. The Clients are able to access the web server but when they try and access th...
Hi Gilles Could I have a CSS load balancing two servers and also have it communicate with a billing server across the network. If yes then how can I do it?Regards,Sushil
Hi, Autonomous 1200 AP [running Cisco IOS]can work as a bridge unit. When I cpnvert this AP to LWAPP will I get the bridge functionality? In case of 1300 AP/Bridge LWAPP is supported only for AP and not for bridge. If I can get the bridge functionali...
Hi Minquan, I believe Cisco 3560 switches does not support WRR. Instead it supports shaped round robin (SRR).Configuration - http://www.cisco.com/en/US/products/hw/switches/ps5528/products_configuration_guide_chapter09186a00807742c0.html#wp1163879Reg...
Hi Maximum 10GE port density supported on any Cisco 4500 chassis are 2. There are no 10GE line cards supported on 4500 switch. 10GE port on 4500 switch is supporetd only through the SUP. If you want higher port density go for 6500 switch.Sushil
