Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have a problem with CiscoWorks Device Faul Manager 2.0.4 I have configured the DFM to check the LAN equipment and sends the notifications via email, single throws alarms within the CiscoWorks but it does not send email.What´s the problem?
Hi,Network is below:fw1|css||---fw2-----monitor server|-------serverMoniter server needs to monitor the interface of fw1 connecting to CSS. The fw1's interface is a public ip address, however, monitor server only can access/monitor private address. S...
This seems unusual but is it possible to turn off load balancing among real IPs and just enable failover (active-passive) among them? If this is possible, can you configure more than two passive/backup reals and just assign priorities or anything sim...
hi,I believe GSLB is suppose to check availability( & other parameters) of servers and then replies to client with the available( or the best) server address for Act/Sby application failover. But in my test config GSLB replies with both the ip addres...
Hi, I have a setup similar to this example http://www.cisco.com/en/US/products/hw/contnetw/ps792/products_configuration_example09186a008016c8e5.shtml HTTP request comes and hits the CSS on the vip through external IP, gets into internal vip IP, which...
hi,I need a sample config for GSLB for the A/S datacenter design. GSLB is configured on CSM. Another question is, should i place CSM on core 6500 switch or on the Datacenter 6500 switch for GSLB operation?Thanx
Hi, I am configuring 2 CSM modules in separate Cat 6509 boxes in the FT mode. I would like to know how each CSM chooses the active and standby mode. Is it that when we configure the first CSM it becomes the active one and subsequently the 2nd CSM bec...
Hi,In an international Global Load Balancing network, I encounters some problems when using RTT values to select the best site. I would like to understand what the GSS does with the "Wait" option (proximity and DNS rule configuration pannels). If the...
I have a VPN concentrator that I have multiple Lan-to-Lan tunnels on. I want to be able to re-direct the traffic to different servers based on the source IP address comming through the tunnel. Each connection already talks to a specific IP address on...
In my configuration, I have 2 real servers. The serverfarm is configured with "predictor leastconns slowstart 60". The current REAL_SLOW_START_ENABLE variable is set to its default value of 3. To test the slow start feature, I suspended on server and...
