Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My current ASA/AnyConnect setup has all RFC 1918 routing down the tunnel and the public IP space goes out via the local provider. I have a request that traffic to a particular site - let'scall it foo123.com at say 5.5.5.50 goes down the tunnel so as ...
I have 7821 MRA phones running 10.3.1.12 firmware reaching CUCM 10 via Expressway. Is there a way of logging - say to syslog - whenever an MRA phone goes to "preservation mode". I'm trying to assess if the complaint of one MRA user - his phone going ...
Most of my sales folks have lots of contacts in their iPhone. If I install jabber on their iPhone and they use the client to call one of their contacts - jabber will try to call (npa)nxx-xxxx - but without the needed 9 to call out. What would be the ...
The manual below says you should be able to store your login information on your MRA phone. But if I look in System > Enterprise Phone Configuration, Device > Device Settings > Common Phone Profile, or Device > Phone I don't see anything relative to ...
So we have the 7821 MRA connecting to Expressway from outside and registering to call manager. But the problem is this: My users are going to have to enter their AD user name and password using the phone keypad no less than oncea week. On Expressway ...
The first thing we tried was setting the refresh interval to 0. This did not work to get rid of the required timeouts. I think we have the answer however in downloading and installing a new device COP file. In the lab our PS person found that propert...
On another document the issue was written more clearly: "CE: A 25-min-long PSTN/Jabber call became oneway audio after hold/resume". That makes more sense.
Checking monitoring of the UCS itself (which I believe is a representation of the active Fabric Interconnect) shows that memory usage over the last year never exceeded 20%.
