Application Networking

Is there a way to create a content rule that absolutely always prefered one service, and then in the event of a failure, would forward requests to the other service attached to the same content rule?

Hi Incase I have all the users coming in through a proxy server then I would have only one Source IP address. Is there a possibility of load sharing based on the users and have sticky session enabled based on the user who initiated the connectionThan...

i want to configure content engin CE566 but i m not getting any help document so if somebody can help me i will be very much helpful towards you.

In debug mode, I set the flow idle-clean to a certain value for testing...now I want to go back to default behavior. In the CLI, it states setting the value to zero "disables". Does that mean it disables clean-up, or just disables the idle-clean time...

Hello.We have a WAP Gateway architecture with three groups of servers that contain, each, a serverfarm of Wap Gateways and one Radius server (the three groups share the same VIP). We need the following behaviour: the Radius traffic that comes from th...

Hi All,I did a failover testing with 2 CSS11503 and found a ftp problem.I ftp one file from the server which behind 2 CSS, I tried to force failover happen by shutdown external interface. The ftp transfering was also terminated. How can I keep file s...

Can CSM do Radius Load Balancing? Seems to be no!!!! if no is there a workaround for this?

Hi: I have a CSM with a SSL module. How do I disable the CSM from sending SSL closure alerts to the client?Also is there a way to increase the amount of time the CSM waits before it send the SSL closure alert. Looks like the default is 14 seconds.Tha...

Hiin CSS debug mode:CSS_XXX(debug)# show redundant-intRedundant-Interfaces: Interface Address: 10.0.239.166 VRID: 3 Redundant Address: 10.0.239.167 Range: 1 State: Backup Master IP: 10.0.239.165 State Chan...

Hi,We have a 2811 router with VPN and NAT configured. We have two internet connection from different ISPs. The speed of our original connection is 2MB up and down. The speed of our new connection is 1MB up and down. We want to configure load balancin...

HiI have a CSS11050 running fine with 9 servers in 3 different pools. I use 1 port of the CSS to connect to a switch, and I use the switch to connect the 9 servers. I have plans to connect an addition 2 servers in the same manner. At present the CSS ...

Hi I know the url filtering can be enabled using the CCSC-SSM of the ASA.Does this use a external database for filtering sites

Is there a way to enable both the old XML in the 7.x.x code and CVDM in the 8.x.x code? Stats were eaiser to retrieve in the XML.

HiDoes the Content Engine store the passwords which are used to access various sites in its cache? As I understand the passwords will be cached in an encrypted form. If they are cached then can I remove them from the cache?Thank youRegardsSushil

Hi guys, I have no experience with IOS server load balancing and I need to present a guide to IOS web Server Load Balancing. Are there any documents listing the best practices for IOS load balancing anywhere? I have been looking. It is technology (a...