Application Networking

I'm writing for a design problem regarding ACNS deployment, Iwish You could help me.We are an italian organization implementing ACNS Network for our e-learning platform.We'd like to configure transparent caching using wccp v.2, the typicaldeployment ...

Hi all,In a moment (without reason) Load Balancer see all services suspend and then down.When reboot this, all come back OK.Version: ap0610405 (6.10 Build 405)Flash (Locked): 3.10 Build 46Flash (Operational): 6.10 Build 405Type: PRIMARYLicensed Cmd S...

I have implemented the forwarding vserver(s) in accordance with Document ID: 26290 from Cisco (Configuring Content Switching Module for Server Load Balancing and Direct Access to RealServers) with minor adjustments for our environment which I think I...

Does anyone have successful experience passing SQL*Net traffic through a CSS-1150*? I have services for Port 1521 open and content rules for them but the traffic dies. Any help or suggestions on this would be appreciated.

On occasion, when I issue "show disk" the response is "The File System is not mounted". Therefore, I cannot archive my configuration or view any log files. I can reboot the switch and all is well for a month or so then back to the same issue. I've se...

Hi folks,Could I use ap-kal-ssl to test ssl v 2.0?If not, did you have any script example to do it?thanks,Renato

How do you deploy AVS? From the white paper, it seems that I just need to buy one and put it at the data center. Or do I need to buy two; one at the data center and one for each spoke sites? Thanks for the clarification.

Hi,I know it is a much answered question and therotically an impossibility (until sometime ago?). Just a quick check with you guys again.Can a live and estabilished SSL session be failed-over to a back-up CSS in the event of primary went offline due ...

I,ve been trying to run CSS11500 07.40.2.02 one-armed DNAT+SNAT with RTP udp 10000-30000.I need to nat client ip addresses.service serv1ip add 90.1.1.1protocol udpactive------ownervip add 10.1.1.1protocol udpadd serv serv1active-------groupvip add 81...

Hi Gurus,I have a kind of a strange behaviour of our our CSS11150 Load-Balancers configured in Active-Standby mode.These LBs monitor the servers and the latters report UP and Down state from the Standby unit while they are always UP from teh Active u...

I want to use more than one subnet of VIPs on a CSS11503. I cannot trunk the uplink. Is it possible to use VIPs that are not associated to a physical interface.

We have a CS-150-LAN Content switch with software version 6.10Build203. Yesterday for no apparent reason we lost connectivity to our website through our CSS. To get around this issue we removed all content rules except for the "everything-else" rule....