Application Networking

I have several regional offices connected through wan to central office. Configuration: 2*7206 with wccp v2 and CE565 and CE560 (CEs clustered).Http traffic from regions thorough wan redirects to ce.. It worked perfectly with acns 5.1.3.15 until i h...

Hi:I need balance packets HTTP but distinguer between method GET and POST. Is it possible?I have installed version 5.0Thanks, Guillermo.

In the Global Proximity Configuration, the "wait" parameter is disabled by default. GSS Documentation says that the GSS does not wait to perform proximity selection if it has not received the appropriate RTT information and proceeds to the next balan...

When the CSS keepalive shows the state as "dying" is it still sending traffic to that server? or is it holding the traffic in its buffer?What does the user see?thanks

I am trying to determine if there is the ability with a css11501 running version 07.40.1.03 to authorize indivdual commands. Basically what I would like the ability to do is extend the "user" security level to have the ability to suspend and re-activ...

Here is my very simple configuration:!Active version: ap0610405configure!************************* INTERFACE *************************interface e1 bridge vlan 20 description "web1"interface e2 bridge vlan 20 description "client"interface e5 brid...

We want to set up a keepalive for a TFTP server. Is it possible to build a script for TFTP? Has someboy an idea to solve this problem? We tried to fetch a file from the server. The server is answereing but because of a differrent source port the CSS...

I need advice regarding the best training course to attend in order to come familiare with cache engines and have the ability to install and run them

I've posted about this subject before because its pretty vague and I've yet to speak to anybody who's got it working in the UK.Basically I have some channels configured that suck in some video's from a webserver (that doesn't have streaming media ser...

I'm new to configuring CSS. I have been able to do simple load balancing, redirects and SSL, but I can’t' seem to get all three to work together. I have looked at all the docs I can find on Cisco's site, but I haven't found any good examples. What...

I have LD416(3.1.4) and configured 1*VIP and 2*Real server. looks it takes about 30 seconds to switching to the other real server when one of failure. Q) How can I reduce the the convergence time?Thanks,

If I manually suspend a service using the suspend command, is it true that the CSS behaviour is different whether the service is in a Layer 3,4 or 5 content rule ? I read that if the service in a Layer-3 or 4 content rule, existing sessions continue ...

Hi, If i upgrade from 4.1.2 to 4.2.1 and have active/standby state, can I just follow the instructions for hitless upgrade and after that invoke the command hw-module csm x standby config-sync without any other change? Regards Mats

Hi,Two switches have one CSM each in redundant mode. Are the failover packets tagged with a higher cos (5) as with the FWSM module?Thanks,Best regards,Pascal

Currently, I am running a cisco 11501 (soft 7.40) with a SSL module configured for front and backend SSL. layer 5 filtering and OWA is working fine except when I try to use a URL link embedded in an email. The URL changes .. for example from (emai...